Free Ford Radio Code Forum

Thank u redrooster all sorted

Cheers Q

LOCK10

To reset LOCK 10 press Preset Button 6 for 10 seconds and the display should reset to CODE ----

This gives 3 more attempts before it fully locks up...so make sure you have the CORRECT code.

LOCK13

LOCK13 means too many wrong codes have been entered.

It can now ONLY be reset by taking it into a Radio Decoding Workshop.

There are no free solutions on the Internet

Hi i need code for 6000NE serial №M332019

Spike wrote:Hi i need code for 6000NE serial №M332019

6734

Ok I tried 6734 it wasn't correct i tried 6733 it was correct code. The radio started for 1 sec and then went back to code menu i entered the code again, nothing different happened. Any ideas ?

redrooster wrote:

Spike wrote:Hi i need code for 6000NE serial №M332019

6734

sorry ...typo
6733 is correct

redrooster wrote:

redrooster wrote:

Spike wrote:Hi i need code for 6000NE serial №M332019

6734

sorry ...typo
6733 is correct

6733 is correct yes. But do you know why when i type the correct code it accept it. the screen goes to radio freaquency and then back to code screen ?

Spike wrote:

redrooster wrote:

redrooster wrote: 6734

sorry ...typo
6733 is correct

6733 is correct yes. But do you know why when i type the correct code it accept it. the screen goes to radio freaquency and then back to code screen ?

The first thing to always check with car radio problems is to make sure all the connectors at the rear are fully pushed in .

Otherwise it could be because the code memory chip is faulty inside the radio.

First try pressing Preset Button 6 for 10 seconds then enter the code again.

If that does not work then remove the radio from the dashboard and leave disconnected overnight.

Put it back the following day and enter the code again.

If that does not work either then the radio will have to be taken in for repair ... or perhaps the better and cheaper option is to buy a working replacement radio ( with a code )

redrooster wrote:

Spike wrote:

redrooster wrote: sorry ...typo
6733 is correct

6733 is correct yes. But do you know why when i type the correct code it accept it. the screen goes to radio freaquency and then back to code screen ?

The first thing to always check with car radio problems is to make sure all the connectors at the rear are fully pushed in .

Otherwise it could be because the code memory chip is faulty inside the radio.

First try pressing Preset Button 6 for 10 seconds then enter the code again.

If that does not work then remove the radio from the dashboard and leave disconnected overnight.

Put it back the following day and enter the code again.

If that does not work either then the radio will have to be taken in for repair ... or perhaps the better and cheaper option is to buy a working replacement radio ( with a code )

Thank you for the info !

Hey please HELLLLP! need cod for cd 6000 M052854